openSUSE Tumbleweed on the Banana Pi BPI-M2 ZERO

This is the first post of a small series about openSUSE on the Banana Pi BPI-M2 ZERO.

Preface

I recently got myself a Banana Pi M2 Zero board while ordering other stuff at an electronics distributor. The M2 zero is the same form factor and feature set as the Raspberry Pi Zero W (the GPIO pin headers are said to be compatible, it has WiFi and Bluetooth built in and an USB OTG port). The CPU is an Allwinner H2+, a quad-core ARM processor running a 1GHz clock speed, RAM size is 512MB. Processing power is probably comparable to a Raspberry Pi 2 board.

I bought the M2 Zero to use it with an RTLSDR stick to receive the signal of my outside RF temperature sensor. This worked with the Raspberry Pi Zero W, but was a bit too much for the slower CPU which has other more important things to do anyway (playing internet radio ;-), so the M2 Zero was a cheap, more powerful alternative. The box will be running headless and thus I do not care about support for graphics and multimedia anyway.

In the end, I switched the RF receiver to a RaspyRFM board whih is using less energy and simpler to use than an RTLSDR stick just to receive some sensors and now the M2 Zero board is free for tinkering...

openSUSE on the M2 Zero

There was already an image available for the Banana Pi M2 Plus (called "sinovoipbpim2plus"), which is the "bigger brother" of the M2 zero, but that image did not boot. Experimenting with the u-boot image from armbian lead to success in "openSUSE Tumbleweed boots with armbian u-boot". Thanks to the friendly openSUSE ARM community, a matching u-boot version for the M2 Zero was built quickly and I could submit the updated image in OBS to get an image ready for the board (called "sinovoipbpim2zero").

Some small things are still to be sorted out, this is why I would suggest you use the image from the home:seife:bananapi repository for now. Since the board has only WiFi networking (more on that in a later post...), you'll need a serial console wired up for initial setup and I strongly suggest to use at least the "openSUSE-Tumbleweed-ARM-X11-..." image and not the JeOS image, since JeOS does not contain NetworkManager and using WiFi with wicked (actually using anything with wicked) is not fun.

So put the image on the SD card, connect the serial console, boot the box up. Log in as root. WiFi connection is easily established then:

nmcli dev wifi connect YOUR_SSID password YOUR_PASSWORD

That's it, have fun! ;-)

Addon note: When I started to write this post, my home:seife:bananapi repo was necessary for actually getting WiFi to work (contained a fixed kernel-firmware package). This has all been submitted to upstream or openSUSE:Factory:ARM now. All that's "special" in my repo now is a slightly extended package selection in the image (the "dtc" package is included) and a fixed config.sh script that makes NetworkManager actually work correctly, including name resolution, see boo#1180234 for details), so the image from openSUSE:Factory:ARM should be "good enough" for most uses already and in the near future I'll probably retire the home:seife:bananapi project or use it just for development stuff).